Fog light installation kit wiring harness 2006 jetta

First of all, you will notice the white Molex connector wired to the blue Delphi headlight socket. This allows for very easy installation. In fact, without this connector, you would have to. The second difference is the wire that we use. The wire is a heavier gauge, 16awg instead of the standard VW 18awg.

In addition, the insulation of the wire is designed to withstand years of oil, water, and heat. It will not crack off like the oem wire. We include a 5 year warranty with our wiring harness. A lot of thought went into the design of this wiring harness, it's a lot better than the original that comes with the car. Toggle menu Free Shipping. Qty: Availability: Ships by Jan 21, Fog Light Assembly - Pair. Qty: Availability: Ships by Apr 14, Request In-Stock Notification An error has occurred.

Please try again. Fog Light Grille - Right. Qty: Availability: Ships by Apr 29, While it is more costly, it insures a seamless experience for you. Most installations take about 30 minutes. A detailed step-bystep instruction manual with pictures is included. Technical support is available should you have any questions. Please note: All wiring harnesses' ship standard with bulb connectors for H10 fog light bulbs. H10 fog light bulbs are used on Mustang GT fog lights and most aftermarket fog lights for the V6 Mustang.

Use a small screwdriver or punch to slide the purple plastic terminal retainer arrow out of the electrical connector. Insert a yellow harness wire into the pin 2 location of each headlight connector This will supply power to the fog light through the main OEM connector. Push the purple plastic retainer back in place to lock all the wires in the connector, then repeat this step at the other headlight. Service Tip: You may need to remove a small green rubber plug from the pin 2 location to make room for the new wire.

This can be easily removed with a small flat-blade screwdriver or pick. Locate one of the two available grommets in the firewall to route the blue harness wire into the cabin. Run the blue wire through the rubber grommet in the firewall, located just above the brake booster. Push the blue wire into terminal 8 of the headlight switch connector. When it is fully inserted, it should click and lock in place. This concludes your installation and should have you all wired up!

Let us know if you have any questions or comments below. Thank you for purchasing, see you next time!